Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
HOW TO USE FLASHCAT USB WITH A SB5101
#2
On the dip switch you want to have 1 On and 2 Off, plug in the flashcat and launch the software, make sure the flashcat is detected, then hit the reset button, now you should now see a tab called AVR Firmware, you load the hex file, hit the program button, then start application

If you want you can flip 2 back to On or you can leave it Off, only difference is if 2 is On when you hit reset it will do a basic reset and not be able to flash AVR
Reply


Messages In This Thread
RE: HOW TO USE FLASHCAT USB WITH A SB5101 - by ricktendo - 16-07-2016, 01:37 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)