+- Haxorware Forums (http://www.haxorware.com/forums)
+-- Forum: General (http://www.haxorware.com/forums/forumdisplay.php?fid=6)
+--- Forum: Modems (http://www.haxorware.com/forums/forumdisplay.php?fid=7)
+--- Thread: HOW TO USE FLASHCAT USB WITH A SB5101 (/showthread.php?tid=4126)
HOW TO USE FLASHCAT USB WITH A SB5101 - caleno18st - 15-07-2016
HOW DO I INSTALL THE FLASHCAT FIRMWARE USB SOFTWARE TO THE UNIT ITSELF
RE: HOW TO USE FLASHCAT USB WITH A SB5101 - ricktendo - 16-07-2016
On the dip switch you want to have 1 On and 2 Off, plug in the flashcat and launch the software, make sure the flashcat is detected, then hit the reset button, now you should now see a tab called AVR Firmware, you load the hex file, hit the program button, then start application
If you want you can flip 2 back to On or you can leave it Off, only difference is if 2 is On when you hit reset it will do a basic reset and not be able to flash AVR
RE: HOW TO USE FLASHCAT USB WITH A SB5101 - madman12 - 16-07-2016
why'd you even answer this rick...
RE: HOW TO USE FLASHCAT USB WITH A SB5101 - LAKING - 20-07-2016
Cause he is not a bitch like you madman