Thread Rating:
  • 1 Vote(s) - 1 Average
  • 1
  • 2
  • 3
  • 4
  • 5
SBG900 Factory Mode
#1
I want to set sbg900 in factory mode.
Like "Haynes Cable Modem Guide Rev1.7.2.pdf" p 113 f I need
a bit file "sbg900.bit". Where can I find the file? Google does not
help.

thanks
p.j.
Reply
#2
No only need the vxwork for Sb5100 ok
Reply
#3
thanks

i am online with a motorola 5101 modem
and i want use a sbg900 modem instead
the 5101.

i enabled factory mode of sbg900 und changed
hfc mac address and serial number.
the modem can download the sb5101.cfg file
from isp but than i get an auth reject
(B301.08)
Do I have to change some modem
certs like:

1.3.6.1.4.1.1166.1.19.4.52.0 cmFactoryCMCertificate
1.3.6.1.4.1.1166.1.19.4.53.0 cmFactoryManCertificate
1.3.6.1.4.1.1166.1.19.6.3.7.0 cmCfgVendorId
1.3.6.1.4.1.1166.1.19.6.3.8.0 cmCfgVendorSpecific
1.3.6.1.4.1.1166.1.19.4.50.0 cmFactoryBigRSAPublicKey
1.3.6.1.4.1.1166.1.19.4.51.0 cmFactoryBigRSAPrivateKey

thanks
p.j.
Reply
#4
(06-04-2009, 12:40 PM)jawlinski Wrote: thanks

i am online with a motorola 5101 modem
and i want use a sbg900 modem instead
the 5101.

i enabled factory mode of sbg900 und changed
hfc mac address and serial number.
the modem can download the sb5101.cfg file
from isp but than i get an auth reject
(B301.08)
Do I have to change some modem
certs like:

1.3.6.1.4.1.1166.1.19.4.52.0 cmFactoryCMCertificate
1.3.6.1.4.1.1166.1.19.4.53.0 cmFactoryManCertificate
1.3.6.1.4.1.1166.1.19.6.3.7.0 cmCfgVendorId
1.3.6.1.4.1.1166.1.19.6.3.8.0 cmCfgVendorSpecific
1.3.6.1.4.1.1166.1.19.4.50.0 cmFactoryBigRSAPublicKey
1.3.6.1.4.1.1166.1.19.4.51.0 cmFactoryBigRSAPrivateKey

thanks
p.j.

Hi there, Factory mode could be set using the VxWorks.st file for the SBG900 model. I have tried it and it works. For me however, I was unfortunately not able to get any of the above mentioned OID's. Not sure why OID's did not work. PS: I am just a newbie and everything i have tried is based on researches conducted by experts. Forgive me if this is not as helpful as if you would expect it to be =)
Reply
#5
You're not expecting somebody to b seated out there over 7 years on a forum waiting for answer your questions, do you? You better start a new thread with your case.
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)