Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
telnet command
#1
Need command line for SB5100Mod to enable factory mode.

Reply
#2
can't you just use snmp, factory mode tool or ip full (shit answer but i just spent the last 40 fucking minutes looking for it but damn i cant find it)
__________________________________________________________________________________
******new discord chat linkĀ https://discord.gg/5BQQbsb*******
Reply
#3
Gain telnet access.
Type cd n/s press enter.
Type allow_config true press enter.
Then type write press enter.
cd /
reset
This should put you into factory mode on the sb5100. Once you're done injecting your certs follow the steps above again but this time instead type allow_config false to get out of factory mode. I have been successful at getting my 5100 back online. It's a tedious process.
Reply
#4
(28-12-2011, 05:22 AM)nutz Wrote: Gain telnet access.
Type cd n/s press enter.
Type allow_config true press enter.
Then type write press enter.
cd /
reset
This should put you into factory mode on the sb5100. Once you're done injecting your certs follow the steps above again but this time instead type allow_config false to get out of factory mode. I have been successful at getting my 5100 back online. It's a tedious process.

Thanks NutZ, I'll give it a try.

Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)