Netgear CG814CCR v2

[saneblane]

Hi i got a Netgear CG814CCR v2 cable modem. Last night i had a power outage and now when i put the modem on, the power light flashes, it blinks then all lights flash, then it turn off and repeats the cycle all over again. I am not able to get an IP adress or anything, so i can't communicate with the modem through the ethernet port. Is it possible to make an unbuffered cable for this modem, and if so, does anyone have the schematics they can share with me please, I would really appreciate it.

Broadcom
BCM3349KPBG.

[drewmerc]

flash it via serial/ttl cable unless your adept at modding toms flash.def's (tho i do believe you can back it up fine with toms, just not flash)

[saneblane]

flash it via serial/ttl cable unless your adept at modding toms flash.def's (tho i do believe you can back it up fine with toms, just not flash)

Thank you for your reply sir. I am a noob to this so always assume i don't know anything. I have done fta and dishcard programming before but first time trying this for a modem. I am currently in a remote location so going to a store is not an option, although i can order it. Do you have a picture of the cable or a link so i can see what it looks like. Or if i can do one DIY, the schematics would be helpful, i have soldering iron and wires around.

[drewmerc]

4th one

[saneblane]

I don't know if this site allows external links. But would the cable in the picture work.

http://www.ebay.com/itm/USB-2-0-to-UART-...2315cfae0b

My computer doesn't have a serial port. Only USB. Thanks

[drewmerc]

yes

[saneblane]

yes

Ok thanks a lot man, I really appreciate it, thanks again and be well.