Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
cant access 192.168.100
#1
just got a modem back from a friend 5101e and cant access modem,think they have changed settings,is there any way of getting back into the haxorware?or do i need to reflash?thanks
Reply
#2
see if you can access telnet if not reflash
__________________________________________________________________________________
******new discord chat linkĀ https://discord.gg/5BQQbsb*******
Reply
#3
Remove coax and restart modem with it removed. Change settings than screw back coax
No I will not help you if only have a few worthless post on the forum.
Reply
#4
or try a different computer or laptop

WITHOUT the coax Cable


i had this issue once
Reply
#5
Is there a physical reset button to have everything reset from default?
Reply
#6
(17-11-2011, 08:58 PM)xlidavidilx Wrote: Is there a physical reset button to have everything reset from default?

no
connect a ttl cable and start hyperterminal then enter these commands (you need to press y on a few of the commands)

cd \cm_hal
scan_stop
cd \
cd non
clear_device
flush
defaults
write

it'll set your modem address to default
__________________________________________________________________________________
******new discord chat linkĀ https://discord.gg/5BQQbsb*******
Reply
#7
hi there'
I have same modem but I can't login 192.168.100.1.but I find the way to login ( I thinks also you don't know usename and password ,like me but I can acc the hawax, now I try to looking for usename and pass )
on comp: run : cmd...ipcofig...def gate is your ip acc to your modem
or maybe ( with me )
1.9.7.3.
let try it
Reply


Forum Jump:


Users browsing this thread: 4 Guest(s)