getting to config page

[Sokalm]

how do i get to the config page on this firmware im usually use to docsis where i type it in the url bar. i have motorala sb5101

also what is all i need for the connection to be valid all i have is a few mac addresses when a friend did his modem awhile back.

[Wichin12]

for haxorware the usual 192.168.100.1

[Sokalm]

for haxorware the usual 192.168.100.1

alright, do i need to just insert the mac in to the right place to get it started or do i need to download the config and upload it to firmware. It a bit confusing to me. Docsis, and SIgma x were a lot easier.

[neo_]

Not to be rude, but no one is going to spoon you the information you are asking. Like the rest of us, you will need to search and research. I suggest you start at the basics with the Haynes Manual and/or Hacking the Cable Modem: What Cable Companies Don't Want You to Know. Even though some of the information is outdated, it will answer your above question.

[Sokalm]

i've research, and it seem that my problem is with the freq. It get stucked on Scanning, and doesn't establish a sync connection.

Where do i go to find out America Frequency. all i am finding is people posting european freq.

[neo_]

I liked your previous post that you deleted better.

[sixteen]

sb5101 is a wast of time, your best bet is to get a D3 modem and some valid certs!

[Sokalm]

I liked your previous post that you deleted better.

lol i rage then i rethink what i was doing and deleted.... i try to make it right.

[neo_]

I liked your previous post that you deleted better.

lol i rage then i rethink what i was doing and deleted.... i try to make it right.

What are your dbmv and signal noise levels?

[Sokalm]

frequency 537 MHz
Status Not synced
Annex DOCSIS
Modulation Unknown
Receive Power -25.6 dBmV
Signal to Noise ratio 23.5 dB
Upstream
Frequency 0 MHz
Channel ID 0
Status Not synced
Mode TDMA
Transmit Power 8.3 dBmV