+- Haxorware Forums (http://www.haxorware.com/forums)
+-- Forum: General (http://www.haxorware.com/forums/forumdisplay.php?fid=6)
+--- Forum: Modems (http://www.haxorware.com/forums/forumdisplay.php?fid=7)
+--- Thread: getting to config page (/showthread.php?tid=2900)
Pages:
1
2
getting to config page - Sokalm - 05-01-2014
how do i get to the config page on this firmware im usually use to docsis where i type it in the url bar. i have motorala sb5101
also what is all i need for the connection to be valid all i have is a few mac addresses when a friend did his modem awhile back.
RE: getting to config page - Wichin12 - 05-01-2014
for haxorware the usual 192.168.100.1
RE: getting to config page - Sokalm - 07-01-2014
(05-01-2014, 01:34 AM)Wichin12 Wrote: for haxorware the usual 192.168.100.1
alright, do i need to just insert the mac in to the right place to get it started or do i need to download the config and upload it to firmware. It a bit confusing to me. Docsis, and SIgma x were a lot easier.
RE: getting to config page - neo_ - 07-01-2014
Not to be rude, but no one is going to spoon you the information you are asking. Like the rest of us, you will need to search and research. I suggest you start at the basics with the Haynes Manual and/or Hacking the Cable Modem: What Cable Companies Don't Want You to Know. Even though some of the information is outdated, it will answer your above question.
RE: getting to config page - Sokalm - 08-01-2014
i've research, and it seem that my problem is with the freq. It get stucked on Scanning, and doesn't establish a sync connection.
Where do i go to find out America Frequency. all i am finding is people posting european freq.
RE: getting to config page - neo_ - 08-01-2014
I liked your previous post that you deleted better.
RE: getting to config page - sixteen - 08-01-2014
sb5101 is a wast of time, your best bet is to get a D3 modem and some valid certs!
RE: getting to config page - Sokalm - 08-01-2014
(08-01-2014, 04:18 AM)neo_ Wrote: I liked your previous post that you deleted better.
lol i rage then i rethink what i was doing and deleted.... i try to make it right.
RE: getting to config page - neo_ - 08-01-2014
(08-01-2014, 12:05 PM)Sokalm Wrote:(08-01-2014, 04:18 AM)neo_ Wrote: I liked your previous post that you deleted better.
lol i rage then i rethink what i was doing and deleted.... i try to make it right.
What are your dbmv and signal noise levels?
RE: getting to config page - Sokalm - 08-01-2014
frequency 537 MHz
Status Not synced
Annex DOCSIS
Modulation Unknown
Receive Power -25.6 dBmV
Signal to Noise ratio 23.5 dB
Upstream
Frequency 0 MHz
Channel ID 0
Status Not synced
Mode TDMA
Transmit Power 8.3 dBmV