08-02-2009, 09:53 AM
Thanks guy's for the Diagrams I found on this site.
I finally was able to do a backup on the modem
I was abble to detect Amd xxxxxxxxx
read all and saved it.
I kept getting blackCat not connected.
Now I need to get it flashed.
Please advise if this is correct IN blackcat.
after I did my back up
clikc on tab Flash / write all /select haxorware11rev30.bin
i understand is the lates bin/ when complete
unhook ribbon cable then I'm done and reboot?
Did I miss any steps?
When I have the modem plug in with the power and cable
what do I do to the pc to get the modem going
do I go into CMD ipconfig /all
then realese
then renew
is this correct?
any other guide you may have or suggest.
Great forum with info and members to correct the problems
I had the modems down for two weeks because I had the wrong
wiring form other forum.
Why do I need the Factory tool
and how I use it.
Your help is appreciated.
Tyfon
I finally was able to do a backup on the modem
I was abble to detect Amd xxxxxxxxx
read all and saved it.
I kept getting blackCat not connected.
Now I need to get it flashed.
Please advise if this is correct IN blackcat.
after I did my back up
clikc on tab Flash / write all /select haxorware11rev30.bin
i understand is the lates bin/ when complete
unhook ribbon cable then I'm done and reboot?
Did I miss any steps?
When I have the modem plug in with the power and cable
what do I do to the pc to get the modem going
do I go into CMD ipconfig /all
then realese
then renew
is this correct?
any other guide you may have or suggest.
Great forum with info and members to correct the problems
I had the modems down for two weeks because I had the wrong
wiring form other forum.
Why do I need the Factory tool
and how I use it.
Your help is appreciated.
Tyfon