Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
no p option
#1
hi

Hi all i dont have the p option on my epc2100r2 ive tried console unlocker but no go

heres what i get in hyper

BCM3349A0
1346890

SA BootLoader Version: 2.1.7l_R3(S) Release Gnu reduced DDR drive
Build Date: Oct 23 2008
Build Time: 16:48:52
Flash detected @0xbe000000

(A). Image 1 Program Header:
Location: 0xbec10000
eCos - hal_diag_init
Init device '/dev/ttydiag'
Init tty channel: 80338648
Init device '/dev/tty0'
Init tty channel: 80338668
Init device '/dev/haldiag'
HAL/diag SERIAL init
Init device '/dev/ser0'
BCM 33XX SERIAL init - dev: 0.2
Set output buffer - buf: 80369f68 len: 2048
Set input buffer - buf: 8036a768 len: 2048
BCM 33XX SERIAL config

Reading Permanent settings from non-vol...
Checksum for permanent settings: 0xf2590556
Settings were read and verified.


Reading Dynamic settings from non-vol...
Checksum

then it sticks at that

is there anything i can do

thanks

also im using a maxx as i dont have a jtag lead

thanks all
Reply


Messages In This Thread
no p option - by welshy9 - 01-04-2010, 08:54 PM
RE: no p option - by drewmerc - 02-04-2010, 09:09 AM
RE: no p option - by welshy9 - 02-04-2010, 12:16 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)