+- Haxorware Forums (http://www.haxorware.com/forums)
+-- Forum: General (http://www.haxorware.com/forums/forumdisplay.php?fid=6)
+--- Forum: Modems (http://www.haxorware.com/forums/forumdisplay.php?fid=7)
+--- Thread: no p option (/showthread.php?tid=466)
no p option - welshy9 - 01-04-2010
hi
Hi all i dont have the p option on my epc2100r2 ive tried console unlocker but no go
heres what i get in hyper
BCM3349A0
1346890
SA BootLoader Version: 2.1.7l_R3(S) Release Gnu reduced DDR drive
Build Date: Oct 23 2008
Build Time: 16:48:52
Flash detected @0xbe000000
(A). Image 1 Program Header:
Location: 0xbec10000
eCos - hal_diag_init
Init device '/dev/ttydiag'
Init tty channel: 80338648
Init device '/dev/tty0'
Init tty channel: 80338668
Init device '/dev/haldiag'
HAL/diag SERIAL init
Init device '/dev/ser0'
BCM 33XX SERIAL init - dev: 0.2
Set output buffer - buf: 80369f68 len: 2048
Set input buffer - buf: 8036a768 len: 2048
BCM 33XX SERIAL config
Reading Permanent settings from non-vol...
Checksum for permanent settings: 0xf2590556
Settings were read and verified.
Reading Dynamic settings from non-vol...
Checksum
then it sticks at that
is there anything i can do
thanks
also im using a maxx as i dont have a jtag lead
thanks all
RE: no p option - drewmerc - 02-04-2010
you know the answer, jtag
RE: no p option - welshy9 - 02-04-2010
ok cheers buddy thaught i could do it with the maxx