hello all, i have a couple of questions about connecting my modem (sb5101) via blackcat usb. i soldered the header pin onto modem board.
problem i'm having is that blackcat (build 300) usb software, AVR firmware (BCUSB.1.09.SPI.hex) does not connect to modem. it says (no flash detected) and on the bottom it says... waiting for device to be connected. then if i try to use AVR firmware (BCUSB.7.01.EJTAG_32K.hex) it says failed to retrive board firmware version.
i followed all there instructions that came with it, but it seems like it is not connecting.
am i not connecting something properly? should the lights be on - on the board?
i'm running windows 7 pro (32bit) if it makes a difference.
any help would greatly be appreciatted
problem i'm having is that blackcat (build 300) usb software, AVR firmware (BCUSB.1.09.SPI.hex) does not connect to modem. it says (no flash detected) and on the bottom it says... waiting for device to be connected. then if i try to use AVR firmware (BCUSB.7.01.EJTAG_32K.hex) it says failed to retrive board firmware version.
i followed all there instructions that came with it, but it seems like it is not connecting.
am i not connecting something properly? should the lights be on - on the board?
i'm running windows 7 pro (32bit) if it makes a difference.
any help would greatly be appreciatted