I have only ever used a parallel JTAG, which was fine, met my needs OK.
No real reason to do anything.
But I found a USB JTAG, it has a prolific serial chip on it.
It was for an Arduino project.
I think it should be useable for cable modems too.
I installed the prolific chip driver, it works in device manager.
I have a couple of DOCSIS 3 units I want to play with, a Motorola, a Cisco, a Scientific Atlanta. Assuming they have JTAG, which I have not yet investigated.
What software for reflashing modems would be usable?
I tried the BlackCat USB software, that doesn't seem to know it's there.
I think the usbjtag.com software only works with their product, which this is not.
Any ideas?
No real reason to do anything.
But I found a USB JTAG, it has a prolific serial chip on it.
It was for an Arduino project.
I think it should be useable for cable modems too.
I installed the prolific chip driver, it works in device manager.
I have a couple of DOCSIS 3 units I want to play with, a Motorola, a Cisco, a Scientific Atlanta. Assuming they have JTAG, which I have not yet investigated.
What software for reflashing modems would be usable?
I tried the BlackCat USB software, that doesn't seem to know it's there.
I think the usbjtag.com software only works with their product, which this is not.
Any ideas?