new but doing a pretty good job...i think? fully operational on sb5101 but....

[KnoxK]

i used another mac to get d11_m_sb5100-silver.cm which is the right config if sb5100 2.8.... is my stealth. when i open that cm in vultureware it shows that for the expected firmware i posted my stealth settings in text im not sure if i have ports set right and if hardware version and bootloader versions are correct i also posted a log with entries from cm /non-vol/show telnet commands after i inserted stealth. also in all my config or cm files even the wg config has 4 lines of co-cvc signiature info with hex code after that. its all the same code what is that im pretty sure I need that. what is the best hex reader or interpreter for that?