23-01-2010, 12:11 AM
I really, really didn't want to do this, but i've been searching and reading for 2 days straight and I can't configure the haxorware settings properly to give me a frequency lock.
I'm using haxorware 1.1rev39 on an Ambit 250/255.
I've flashed and updated the firmware as per the instructions from here (and other guides) so I might be missing something simple because i've went a bit crossed-eyed.
I know my freq is 402750000 because I checked it earlier in the week before I flashed. Can I use the original MAC until I get haxorware set-up properly? If I can get to the vm activation page with this mac, then I know haxorware is set-up correctly and all I need to do is get a new MAC, right?
My settings are basic (as per every tutorial instructions), and i'm not forcing any configs.
Annex: both
freq: tried them all (even though I know it should be 402750000)
BPi: tried them all though i'm in a pure area so it should be 1.0, right?
In the log, all I get is:
"SYNC synchronisation failure. Failed to acquire QAM/QPSK symbol timing"
I'm really stumped here, i've tried every combination of settings possible and I still can't lock on.
Am I completely missing something here?
Any help at all would be greatly appreciated.
I'm using haxorware 1.1rev39 on an Ambit 250/255.
I've flashed and updated the firmware as per the instructions from here (and other guides) so I might be missing something simple because i've went a bit crossed-eyed.
I know my freq is 402750000 because I checked it earlier in the week before I flashed. Can I use the original MAC until I get haxorware set-up properly? If I can get to the vm activation page with this mac, then I know haxorware is set-up correctly and all I need to do is get a new MAC, right?
My settings are basic (as per every tutorial instructions), and i'm not forcing any configs.
Annex: both
freq: tried them all (even though I know it should be 402750000)
BPi: tried them all though i'm in a pure area so it should be 1.0, right?
In the log, all I get is:
"SYNC synchronisation failure. Failed to acquire QAM/QPSK symbol timing"
I'm really stumped here, i've tried every combination of settings possible and I still can't lock on.
Am I completely missing something here?
Any help at all would be greatly appreciated.