+- Haxorware Forums (http://www.haxorware.com/forums)
+-- Forum: General (http://www.haxorware.com/forums/forumdisplay.php?fid=6)
+--- Forum: Modems (http://www.haxorware.com/forums/forumdisplay.php?fid=7)
+--- Thread: Ambit 250/255 with haxorware 1.1rev39 (/showthread.php?tid=381)
Ambit 250/255 with haxorware 1.1rev39 - sputnik - 23-01-2010
I really, really didn't want to do this, but i've been searching and reading for 2 days straight and I can't configure the haxorware settings properly to give me a frequency lock.
I'm using haxorware 1.1rev39 on an Ambit 250/255.
I've flashed and updated the firmware as per the instructions from here (and other guides) so I might be missing something simple because i've went a bit crossed-eyed.
I know my freq is 402750000 because I checked it earlier in the week before I flashed. Can I use the original MAC until I get haxorware set-up properly? If I can get to the vm activation page with this mac, then I know haxorware is set-up correctly and all I need to do is get a new MAC, right?
My settings are basic (as per every tutorial instructions), and i'm not forcing any configs.
Annex: both
freq: tried them all (even though I know it should be 402750000)
BPi: tried them all though i'm in a pure area so it should be 1.0, right?
In the log, all I get is:
"SYNC synchronisation failure. Failed to acquire QAM/QPSK symbol timing"
I'm really stumped here, i've tried every combination of settings possible and I still can't lock on.
Am I completely missing something here?
Any help at all would be greatly appreciated.
RE: Ambit 250/255 with haxorware 1.1rev39 - drewmerc - 23-01-2010
only way your going to know for sure is a telnet log of the entire boot up process using a max cable
RE: Ambit 250/255 with haxorware 1.1rev39 - sputnik - 23-01-2010
Ok. I'll do it later today and see what comes up.
Attached is the telnet boot log.
I'll be the first to admit that i'm a noob at all this, I only follwed the guides posted everywhere online to even flash the thing. I don't even know what i'm looking for in this boot log.
If anyone can help, that would be amazing.
RE: Ambit 250/255 with haxorware 1.1rev39 - sputnik - 24-01-2010
Fixed.
Feed was loose at the wall. Oops.
I feel like a right prick.
RE: Ambit 250/255 with haxorware 1.1rev39 - drewmerc - 24-01-2010
(24-01-2010, 12:43 AM)sputnik Wrote: Fixed.
Feed was loose at the wall. Oops.
I feel like a right prick.
hahahahahahahahaha
RE: Ambit 250/255 with haxorware 1.1rev39 - sputnik - 24-01-2010
(24-01-2010, 01:05 AM)drewmerc Wrote:(24-01-2010, 12:43 AM)sputnik Wrote: Fixed.
Feed was loose at the wall. Oops.
I feel like a right prick.
hahahahahahahahaha
I had been at it for so long, I forgot to check the obvious stuff. At least I know now that I understood the tuts.
Beginning to go a bit mental there for a bit tbh.....
