15-04-2013, 06:09 PM
(This post was last modified: 15-04-2013, 06:11 PM by therealdeal.)
Hello everyone i'm not exactly new to this but I need to keep learning and find more information about everything that's going on especially after certificate and BPI + security stuff.
ok so I usually just go to my cmd (command prompt) then I telnet into my SB5101 using haxorware
telnet 192.168.100.1
then type root as the user name and password admin. fine it goes into it without problems... however there are a lot of commands I am not familiar with. I've been playing around using help already but I just want to know how to properly create the haxorware telnet log to troubleshoot and what not. I am getting the CVC valiadation failure on my modem and I understand that haxorware log is not enough therefore I am doing what the pros are doing trying to learn the right way. let me know if someone can help me or point me into the right direction. Thank you.
Well i'm trying to ask if I am getting into the telnet correctly. and how to give it a command that will create a telnet log. Can anyone help me.
ok so I usually just go to my cmd (command prompt) then I telnet into my SB5101 using haxorware
telnet 192.168.100.1
then type root as the user name and password admin. fine it goes into it without problems... however there are a lot of commands I am not familiar with. I've been playing around using help already but I just want to know how to properly create the haxorware telnet log to troubleshoot and what not. I am getting the CVC valiadation failure on my modem and I understand that haxorware log is not enough therefore I am doing what the pros are doing trying to learn the right way. let me know if someone can help me or point me into the right direction. Thank you.
Well i'm trying to ask if I am getting into the telnet correctly. and how to give it a command that will create a telnet log. Can anyone help me.