19-07-2012, 06:51 AM
(This post was last modified: 19-07-2012, 06:58 AM by PumaTechTV.)
(19-07-2012, 06:37 AM)drewmerc Wrote: no, no, no pci cards don't work (ok some do but it's hit and miss)
http://www.haxorware.com/forums/thread-3...ml#pid1896
Really? That sucks. I made sure the card had the ability to be remapped to legacy I/O addresses. Does that make a difference? Here are the card specs:
Quote:PCI lower profile single port parallel card
Easy Plug & installation automatically selects IRQ and I/O address
Supports PCI IRQ sharing-saves valuable resources for other expansion card
Support 32-bit PCI Bus, PCI Specification 2.1
Support Re-mapping to Legacy Address
Supports more than one card into system
Parallel Port:
Build-in SPP, PS2, EPP, ECP compatible IEEE 1284 printer port
Fast data rates up to 1.5Mbytes/sec
Build-in 16 Byte FIFO
(some) Supported Parallel Devices:
Bank Passbook Printer, CF/SM/MMC/SD/PCMCIA reader, CD-R/RWS, EPROM Programmer, Intelligent UPS, Laplink, LS120 Drive, Plotter, Receipt Printer, Scanner etc
The link to the site of my card is this one
http://www.sybausa.com/productInfo.php?iid=716
Also, do you happen to know what addresses blackcat searches for the lpt port? Thanks.
Oh and thanks for the PM.