5101, no lights after loading hax v39

[pendrag]

Hi,

I loaded hax v39 using parallel jtag. No errors but when I reset modem I see no booting lights at all. I have heard that it might be the standby button might be the cause because hax disable standby button. Is there a way to work around this issue?

Thanks.

[newname]

Hi,

I loaded hax v39 using parallel jtag. No errors but when I reset modem I see no booting lights at all. I have heard that it might be the standby button might be the cause because hax disable standby button. Is there a way to work around this issue?

Thanks.

you installed hax over a stock 5101 that was working properly before you installed hax?

[pendrag]

Hi,

I loaded hax v39 using parallel jtag. No errors but when I reset modem I see no booting lights at all. I have heard that it might be the standby button might be the cause because hax disable standby button. Is there a way to work around this issue?

Thanks.

you installed hax over a stock 5101 that was working properly before you installed hax?

Yes, it was working properly before loading hax. Booting lights were showing just fine. Thx.

[sixteen]

You killed it.

[pendrag]

You killed it.

Just to learn from my mistake. What must I had done before loading hax on this model? I am assuming there is nothing I can do now, right?

[dragonlord7791]

flash this on it whith verify and skyp error at 67 percent...
is a full flash hax

https://mega.co.nz/#!MZQy3ZrA!y-0EziWk7E...prE_wXxdLg

i was using whit black cats swarzerkaze,and alwais work,the modem will back to life

[pendrag]

flash this on it whith verify and skyp error at 67 percent...
is a full flash hax

https://mega.co.nz/#!MZQy3ZrA!y-0EziWk7E...prE_wXxdLg

i was using whit black cats swarzerkaze,and alwais work,the modem will back to life

Gee, thx man, I will try it and let you know how it goes. Regards.

[raven1783]

flash this on it whith verify and skyp error at 67 percent...
is a full flash hax

https://mega.co.nz/#!MZQy3ZrA!y-0EziWk7E...prE_wXxdLg

i was using whit black cats swarzerkaze,and alwais work,the modem will back to life

apparently i did the same thing, do you by any chance have a similar file but with rev 39 on it?

[southernyankey1970]

Reflash with this.

THEN reflash hax 39


Revive the cm with the old, whored-out 5101 dump and then when it boots normally flash Hax. Follow the guides for this.

[modembricker]

Doesnt he have to flash a boot file before he can flash a 2mb dump?