sb5101i - receive light blinking

[jofre]

hello all

I´m trying to upgrade my sb5101i

it´s currently with it´s original firmware but when I connect the coaxial cable the power lights gets solid and receive keeps blinking - pc activity will light up and blink too.

what may be happening?

the cable is ok, I have another modem on it and it´s working fine it´s a 5100

the ISP has no BPI

I already flashed haxor 1.1. rev 32 but the results were the same - receive blinking.

any clues?

this is the telnet log:

0x0001937a [CmDocsisCtlThread] BcmCmDocsisCtlThread::StartUsInit: (CmDocsisCtlT
hread) Locked on the downstream. Waiting for UCDs...

******************************************
DOWNSTREAM STATUS
******************************************
Tuner Frequency = 633000000 Hz
Carrier Offset = 11 Hz
Symbol rate = 5360537 sym/sec
SNR = 37 dB
QAM Mode = QAM256
Tuner AGC = 0xfff00000
IF AGC = 0x14614ac0
Power Level = 4 dB
QAM = LOCKED
FEC = LOCKED
******************************************

after this, it will reset.

everytime it reaches for a downstream frequency it will reset

thank you so much

[lprot]

everytime it reaches for a downstream frequency it will reset
thank you so much

Try to change to EuroDocsis or Both bands in config page. Maybe it will help.

[rajkosto]

disable ignore unknown messages in settings