+- Haxorware Forums (http://www.haxorware.com/forums)
+-- Forum: General (http://www.haxorware.com/forums/forumdisplay.php?fid=6)
+--- Forum: Modems (http://www.haxorware.com/forums/forumdisplay.php?fid=7)
+--- Thread: sb5101i - receive light blinking (/showthread.php?tid=230)
sb5101i - receive light blinking - jofre - 13-07-2009
hello all
I´m trying to upgrade my sb5101i
it´s currently with it´s original firmware but when I connect the coaxial cable the power lights gets solid and receive keeps blinking - pc activity will light up and blink too.
what may be happening?
the cable is ok, I have another modem on it and it´s working fine it´s a 5100
the ISP has no BPI
I already flashed haxor 1.1. rev 32 but the results were the same - receive blinking.
any clues?
this is the telnet log:
0x0001937a [CmDocsisCtlThread] BcmCmDocsisCtlThread::StartUsInit: (CmDocsisCtlT
hread) Locked on the downstream. Waiting for UCDs...
******************************************
DOWNSTREAM STATUS
******************************************
Tuner Frequency = 633000000 Hz
Carrier Offset = 11 Hz
Symbol rate = 5360537 sym/sec
SNR = 37 dB
QAM Mode = QAM256
Tuner AGC = 0xfff00000
IF AGC = 0x14614ac0
Power Level = 4 dB
QAM = LOCKED
FEC = LOCKED
******************************************
after this, it will reset.
everytime it reaches for a downstream frequency it will reset
thank you so much
RE: sb5101i - receive light blinking - lprot - 16-07-2009
(13-07-2009, 05:06 AM)jofre Wrote: everytime it reaches for a downstream frequency it will reset
thank you so much
Try to change to EuroDocsis or Both bands in config page. Maybe it will help.
RE: sb5101i - receive light blinking - rajkosto - 21-07-2009
disable ignore unknown messages in settings