Modem gets booted - Printable Version +- Haxorware Forums (http://www.haxorware.com/forums) +-- Forum: General (http://www.haxorware.com/forums/forumdisplay.php?fid=6) +--- Forum: Modems (http://www.haxorware.com/forums/forumdisplay.php?fid=7) +--- Thread: Modem gets booted (/showthread.php?tid=1804) |
RE: Modem gets booted - lefont - 29-07-2012 (29-07-2012, 06:43 AM)Tropical Wrote: Calm Down It Was A Joke. I dont joke to avoid offending anyone. Im here for the technical part of it. RE: Modem gets booted - southernyankey1970 - 29-07-2012 What are your signal levels like? anything between -10 and -15 can keep the cm from syncing. Different modems operate on their own....i have one or two that refuse to lock on anything less than -10 and some that will run on -17. A signal like this is about as pretty as it gets. I bypass the rest of the house with a run of quality RG6 from the tap to my Cm. Frequency 555000000 Hz Signal To Noise Ratio 40.0 dB Power Level 0.6 dBmV The Downstream Power Level reading is a snapshot taken at the time this page was requested. Please Reload/Refresh this Page for a new reading Upstream Value Channel ID 2 Frequency 29600000 Hz Power 43.4 dBm RE: Modem gets booted - lefont - 29-07-2012 (29-07-2012, 03:43 PM)southernyankey1970 Wrote: What are your signal levels like? anything between -10 and -15 can keep the cm from syncing. Different modems operate on their own....i have one or two that refuse to lock on anything less than -10 and some that will run on -17. This is what I have: Frequency 681 MHz Status Locked Annex DOCSIS Modulation QAM256 Symbol Rate 5360537 sym/sec Receive Power -19.2 dBmV Signal to Noise ratio 31.8 dB Upstream Frequency 36 MHz Channel ID 2 Status Ready Mode ATDMA Symbol Rate 5120000 sym/sec Transmit Power 54.0 dBmV What you think of it? This is what I get. I don't know if this is close to the real speed of the cfg file as far as speedtest goes when doing a test. RE: Modem gets booted - southernyankey1970 - 29-07-2012 Receive Power -19.2 dBmV Signal to Noise ratio 31.8 dB just what I thought... your modem is deaf. Fix your signal. Do what i did if you can. Too many splitters between you and the tap. RE: Modem gets booted - lefont - 29-07-2012 (29-07-2012, 05:05 PM)southernyankey1970 Wrote: Receive Power -19.2 dBmV I'll do that sometime this week. Thank you Southernyankey1970. RE: Modem gets booted - lefont - 30-07-2012 (29-07-2012, 05:05 PM)southernyankey1970 Wrote: Receive Power -19.2 dBmV Well Southernyankey1970 A+ to you take a look. What you think? Frequency 681 MHz Status Locked Annex DOCSIS Modulation QAM256 Symbol Rate 5360537 sym/sec Receive Power -14.5 dBmV Signal to Noise ratio 34.8 dB Upstream Frequency 36 MHz Channel ID 2 Status Ready Mode ATDMA Symbol Rate 5120000 sym/sec Transmit Power 53.2 dBmV RE: Modem gets booted - southernyankey1970 - 30-07-2012 Receive Power -14.5 dBmV Marginal but doable. Config file has nothing to do with the signal quality. good job. the closer to 0 db the better. RE: Modem gets booted - lefont - 30-07-2012 (30-07-2012, 02:33 AM)southernyankey1970 Wrote: Receive Power -14.5 dBmV Marginal but doable. Config file has nothing to do with the signal quality. I was mentioning the config file regarding speed testing on Speedtest.net. By the way, is a speedtier cfg suppose to be fast or "special". Or is reserve for higher monthly subscription? Never mind the question, I found the answer on Cable Inside Scoop. RE: Modem gets booted - southernyankey1970 - 30-07-2012 should be 22/4 RE: Modem gets booted - lefont - 30-07-2012 (30-07-2012, 04:14 AM)southernyankey1970 Wrote: should be 22/4 Yeah, that's about right. |