+- Haxorware Forums (http://www.haxorware.com/forums)
+-- Forum: General (http://www.haxorware.com/forums/forumdisplay.php?fid=6)
+--- Forum: Modems (http://www.haxorware.com/forums/forumdisplay.php?fid=7)
+--- Thread: Question about modren day Flashing (/showthread.php?tid=5645)
Pages:
1
2
RE: Question about modren day Flashing - Flup3 - 23-11-2017
neo_ wrote:
It's also important, power on then modem normally with it's own power source. Then, you should only have 3 cables for UART - Ground, Rx, Tx. Find the right ones and you'll see something.
I Tried this on windows 10 and XP (virtual) on 2 modemboards , but all I get it this :
drewmerc wrote:
the looper your talking about is just connecting tx and rx and typing into terminal should echo back (thus telling you it works).
I tested this , but Putty gives me the same screen .
Will the Chinese FT232H work with BlackCat/FlashCat or is there some kind of check in the software ?
RE: Question about modren day Flashing - drewmerc - 23-11-2017
drewmerc wrote:
Will the Chinese FT232H work with BlackCat/FlashCat or is there some kind of check in the software ?
[/quote]
Toms jtag utility for jtag and flashrom for spi
If you want to use the flashcat software buy a flashcat (or a teensy2 as the firmware should be comparable tho untested)