Thread Rating:
  • 1 Vote(s) - 1 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Flashcat USB Status : disconnected?
#11
Hang on a sec.....once drew finishes his tea and crumpets....he will give you a few more tips.....unless of course he has a cricket match to go to.
Reply
#12
Is there any settings I would have to put windows 7 and FC classic
Reply
#13
Brick 
(06-10-2019, 01:20 PM)newname Wrote: Hang on a sec.....once drew finishes his tea and crumpets....he will give you a few more tips.....unless of course he has a cricket match to go to.
Sounds like the rapper 21 Savage Big Grin
Reply
#14
(24-03-2015, 07:05 AM)drewmerc Wrote: hit the reset button

Help me Out Drew I haven’t slept pleaseeee
Reply
#15
hold the reset button and then plug it in, if that fails flip the switches and try again
__________________________________________________________________________________
******new discord chat link https://discord.gg/5BQQbsb*******
Reply
#16
I tried it an switched the switches every way and it still blinks do I need a tftp set up
Reply
#17
what are you trying to do?
__________________________________________________________________________________
******new discord chat link https://discord.gg/5BQQbsb*******
Reply
#18
Just make my fc visible.. do I have to flash it with boot utility? I’m stuck
Reply
#19
let me see if I understand @Andrew956 ...

Do you have your FCUSB with problems to recognize?
You can do the following:

° lower the switch in bootloader mode, there you have an example

[Image: 0953d4065f5c1ef9ab603b7d421914a1.png]

° press the bootloader button with the fcusb obviously connected, no matter if the software is not open.
° open any version of the Flashcatusb software [compatible with the pcb version of fcusb classic]
° click AVR Firmware and Load File
° select fw FCUSB.CLASSIC.x.xx.PCBx.x.hex compatible with your version of Flascatusb classic.
° click Program
° after it is programmed, click on Start Application
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)