11-08-2015, 09:50 PM
I got a chance to try the updated pin out at lunch. The documentation had this pin out:
Here is an extract from the documentation that I cropped out:
New pin out
The pin out for the SB5100 that I used was from this thread:
http://www.usbjtag.com/vbforum/showthread.php?t=217
I even tried flipping the cable after as stated in this thread:
http://www.haxorware.com/forums/showthread.php?tid=1249
Still no luck.
However I had one question to ask and I believe this can be answered by anyone who uses the blackcat usb device. When trying to connect to the target board does it matter what mode you are in DFU or Application. From my reading I'm understanding that DFU mode is only used to program the blackcat device itself, so I believe when reading the RAM contents or flashing the modem it should be in "Applicaiton mode". I'm a right?
Honestly I tried both but I just want to understand how it works.
Here is an extract from the documentation that I cropped out:
New pin out
The pin out for the SB5100 that I used was from this thread:
http://www.usbjtag.com/vbforum/showthread.php?t=217
I even tried flipping the cable after as stated in this thread:
http://www.haxorware.com/forums/showthread.php?tid=1249
Still no luck.
However I had one question to ask and I believe this can be answered by anyone who uses the blackcat usb device. When trying to connect to the target board does it matter what mode you are in DFU or Application. From my reading I'm understanding that DFU mode is only used to program the blackcat device itself, so I believe when reading the RAM contents or flashing the modem it should be in "Applicaiton mode". I'm a right?
Honestly I tried both but I just want to understand how it works.