29-06-2015, 12:24 PM
Yeah, I know that error IS the problem.. I reckon I used an older 6120 tut, and xml, worked at the time, but by updating usbjtag software, it's loaded a different 6120 (before i foun the proper ubee xml) and upon flashing, screwed the flash part's differently.. dont read sbh unless they can corect their error's.. I like how they just leave it all for folks to mess up their box's, instead of updating THEIR mistakes, and leave it to paying customer's to realise.. vip is paying customers, right?
Ubee's have a catch, they reset spi after serial access and not saving upon reboot, (initial access will wipe chip) it's like, if you dont flash the new bootloader then, perm reset's, no matter what you load after, and I think this is what happened, and any other firmware load, but not retain certain needed settings.. even from any 8mb, stock or not.. expaining the eth0, in route it shows as up, when clearly it is not.. or it's hidden by isp setting's..
Ubee's have a catch, they reset spi after serial access and not saving upon reboot, (initial access will wipe chip) it's like, if you dont flash the new bootloader then, perm reset's, no matter what you load after, and I think this is what happened, and any other firmware load, but not retain certain needed settings.. even from any 8mb, stock or not.. expaining the eth0, in route it shows as up, when clearly it is not.. or it's hidden by isp setting's..