Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Need 8x4 firmware for dpc/epc3010
#1
anyone have a firmware that connects with the 8 channels?
Reply
#2
I know I am quite late to the party, and I don't even have DSL internet anymore, however I have two of these laying around and got back in here to do what I can with them. I would like to try to do something and break them insted of just throwing them out.

I have taken them a part, but I'm not sure how I would go about extracting the firmware?
Reply
#3
(14-06-2015, 10:36 PM)christianrodher Wrote: anyone have a firmware that connects with the 8 channels?

like forceware, or stock? Huh
Reply
#4
if anyone still needs, here is a few, i dont know which is which, i know one has an unshadowed NV. as always, youre welcome, and keep on testing.
https://mega.nz/#!uJ1VAJgB!nheZSDu65p0DP...ReMlRJvbNU
Reply
#5
(01-05-2018, 07:41 AM)occalifornia Wrote:
(14-06-2015, 10:36 PM)christianrodher Wrote: anyone have a firmware that connects with the 8 channels?

like forceware, or stock? Huh
Forceware doesn't work on the 3010 cuz it's Broadcomm
Reply
#6
I think the reason he wanted this firmware is because it appears you can force config using this stock firmware
Reply
#7
yes you can, in fact, most BCM modems to this date support fake_reg and Force_config, including 6183 and CM8200.
Reply
#8
force config + dhcp_settings never worked using local tftp.
[Image: 7318038438.png]
Reply
#9
(04-05-2018, 05:28 PM)demonspride Wrote: yes you can, in fact, most BCM modems to this date support fake_reg and Force_config, including 6183 and CM8200.

Force_config is not tftpenforce bypass, true?
Reply
#10
Ola como estas soy chano yo tengo un modem 6183 y1602 los dos son arris si se podran echar andar
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)