Thread Rating:
  • 1 Vote(s) - 1 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Getting ready to flash a 6121
#1
Ok guys, after my bricking of a DPC3000 last year (the one that someone here kept), I am going to attempt to flash a 6121. I found a tutorial here but it involves soldering and ribbon cables. I dont want to do all of that, just use my test clip and usbjtagnt.

From experience, can someone let me know the easiest way to do this?
Reply
#2
If you dont want to go through the trouble of soldering, Use a breadboard in between the test clip and the usbjtag so you can swap the necessary pins. You will still need to connect the isp and source 3.3v though.

Off topic here, but i sent you a PM the other day, not sure if it went though.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)