Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Sb6120 send/recieve solid blue light, won't get online
#1
So my modem stopped working out of no where earlier today. At first, All of the lights were normal but wouldn't go to the main page to get online... Noww a few hours later, the send & receive light is solid blue while the other lights are all normal. Im aware of TW updating their modems to Sb6121. Do i need to update to a new box, update firmware? I attached pictures of my signal strength and log. Any advice?


Attached Files Thumbnail(s)
               
Reply
#2
What you need to do is make a service call. This modem is a D3 no need to change it and the firmware is not a hack firmware.
Reply
#3
(29-10-2014, 02:32 PM)sixteen Wrote: What you need to do is make a service call. This modem is a D3 no need to change it and the firmware is not a hack firmware.

its a modded modem, i called up the guy who hooked me up with it, he said i need new certs? any opinions ?
Reply
#4
(31-10-2014, 10:51 AM)samtcuhhz Wrote:
(29-10-2014, 02:32 PM)sixteen Wrote: What you need to do is make a service call. This modem is a D3 no need to change it and the firmware is not a hack firmware.

its a modded modem, i called up the guy who hooked me up with it, he said i need new certs? any opinions ?
Dwl, he tell you it need new certs, am not seeing forceware on it but what do i know, i think he clone a legit modem and make about 4-5 clone out of it and sell you an others.
Reply
#5
I think that modem has Alpha firmware instead of forceware since alpha don't change the GUI of modems.
Reply
#6
(31-10-2014, 11:21 PM)Wichin12 Wrote: I think that modem has Alpha firmware instead of forceware since alpha don't change the GUI of modems.
Ok, just like FIBERWARE, never use alpha.
Reply
#7
How do you change certs or even gain control over full admin area when you don't have it
Reply
#8
(13-12-2016, 05:12 AM)AllAccess Wrote: How do you change certs or even gain control over full admin area when you don't have it

put forceware on it
Reply


Forum Jump:


Users browsing this thread: 3 Guest(s)