Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Change DPC2100r2 BOOTR & SW_REV
#1
Looking for the OID's to change these two values in NonVol. (Original WebSTAR firmware, not Haxorware)
Crappy isp give you a modem and whatever firmware it came with is what it will stay with. Had a problem logging into control panel with old firmware, went away after I upgraded it.
Now I want to spoof the previous firmware's software and boot versions so its not noticed (these bellow)

Quote:Descripcion: S-A WebSTAR DPC2100r2 Series DOCSIS Cable Modem Ethernet+USB <<HW_REV: 2.0; VENDOR: S-A; BOOTR: 2.1.6; SW_REV: v2.0.2r1244-050203; MODEL: DPC2100r2>>

Already know how to use snmp to set it to factory mode, just need the OID's to those two values

Thank you
Reply
#2
just do it manually with a hex editor
__________________________________________________________________________________
******new discord chat link https://discord.gg/5BQQbsb*******
Reply
#3
The thing about that is nonvol needs to be a certain size, I fear adding/deleting stuff from it manually may cause harm
Reply
#4
true but you dont add any values you just change them example 2.1.6 becomes 2.1.7
the will be no filesize change, it only gets tricky when the numbers are of a different length
__________________________________________________________________________________
******new discord chat link https://discord.gg/5BQQbsb*******
Reply
#5
The bootr is 2.1.6d and I want to change it to 2.1.6, the sw_rev is same lenght
Reply
#6
when that happens i just copy whatever follows the d to replace the d
Code:
00 01 02 03 04 05 06 07 2 . 1 . 6 d  /
00 01 02 03 04 05 07 07 2 . 1 . 6 /  /
(sorry no hex editor to had)
__________________________________________________________________________________
******new discord chat link https://discord.gg/5BQQbsb*******
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)