Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
sb5101i - receive light blinking
#1
hello all

I´m trying to upgrade my sb5101i

it´s currently with it´s original firmware but when I connect the coaxial cable the power lights gets solid and receive keeps blinking - pc activity will light up and blink too.

what may be happening?

the cable is ok, I have another modem on it and it´s working fine it´s a 5100

the ISP has no BPI

I already flashed haxor 1.1. rev 32 but the results were the same - receive blinking.

any clues?

this is the telnet log:

0x0001937a [CmDocsisCtlThread] BcmCmDocsisCtlThread::StartUsInit: (CmDocsisCtlT
hread) Locked on the downstream. Waiting for UCDs...

******************************************
DOWNSTREAM STATUS
******************************************
Tuner Frequency = 633000000 Hz
Carrier Offset = 11 Hz
Symbol rate = 5360537 sym/sec
SNR = 37 dB
QAM Mode = QAM256
Tuner AGC = 0xfff00000
IF AGC = 0x14614ac0
Power Level = 4 dB
QAM = LOCKED
FEC = LOCKED
******************************************

after this, it will reset.

everytime it reaches for a downstream frequency it will reset

thank you so much
Reply
#2
(13-07-2009, 05:06 AM)jofre Wrote: everytime it reaches for a downstream frequency it will reset
thank you so much

Try to change to EuroDocsis or Both bands in config page. Maybe it will help.
Reply
#3
disable ignore unknown messages in settings
[Image: 2qu0z8h.gif]
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)