Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
what is this crap??mismatch..
#1
i keep getting a mismatch error.. when i use my usb-blackcat..
what is going on???
Reply
#2
never seen it, what are you trying to do (i'd guess at writing wrong firmware)
__________________________________________________________________________________
******new discord chat link https://discord.gg/5BQQbsb*******
Reply
#3
im putting the org 2mb dump back on..
Reply
#4
well in my experience i'm guessing miss match is the same as address out of range so is it the 2mb dump i posted before your trying to flash and not the 8mb that was also in the archive
__________________________________________________________________________________
******new discord chat link https://discord.gg/5BQQbsb*******
Reply
#5
ya the one that says flash and i allso tryed the back up one for my other 5101.
Reply
#6
try just flashing the bootloader, then rebooting
or trying to pause the bootloader with a serial cable (and flash that way)
__________________________________________________________________________________
******new discord chat link https://discord.gg/5BQQbsb*******
Reply
#7
what do thay meen buy offset of 10000 meen??
(05-01-2012, 03:05 AM)GBABY4201 Wrote: what do thay meen buy offset of 10000 meen??

were can i find SchwarzeKatze for the 5101??
(05-01-2012, 03:05 AM)GBABY4201 Wrote: what do thay meen buy offset of 10000 meen??
(05-01-2012, 03:05 AM)GBABY4201 Wrote: what do thay meen buy offset of 10000 meen??

were can i find SchwarzeKatze for the 5101??

who dose the sigma's firmware??? what the website for them??
Reply
#8
offset=memory location of were to start flashing and were to end


http://www.megaupload.com/?d=TM8PS5UN
__________________________________________________________________________________
******new discord chat link https://discord.gg/5BQQbsb*******
Reply
#9
i think i understand what your saying tell me if im wrong..
offset is like this 0x10000..??or 0x00010000,, were wood this be set at if im right??
your download is for the old version 5100 4200 and 4100
i need it for the 5101..
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)