hi all, great forum and some very good reading
i have a problem with a 2100 i have flashed it with 1haxw1.39 and it wont connect to 192 i have flashed with a few different fw and get all lights on modem to no lights im using blackcatusb, it detects flash and can program it no problem but cant get to the 192 and light on pc lan card dont light up, i have the bcusb soldered to the modem but have disconnected it from bcusb and tried rebooting modem with all cables on and off but same results, only thing i can say id a problem is the reset button has been damaged and is no longer present but not sure if this could cause a problem, any info would be appresiated
Cheers Mick
the reset button would not cause this as in some versions it's not there (unless theres a solder bridge)
just try flashing a bootloader and a firmware image and not using the cfi_flash tab
__________________________________________________________________________________
******new discord chat link https://discord.gg/5BQQbsb*******
ok, thanks
so flash bootloader then flash with haxorware11rev39-DIAG.bin would the bootloader from the bcusb be fine or do i need a specific for the 2100
cheers Mick
hi, i flashed with new bootloader and bcusb says i have fw ecram_sto.bin currently installed on the board it says rev:2.30 b its got the bc3349 chip can anyone help with correct bootloader and correct firmware to install or what im doing wrong
cheers Mick
hi and thanks again for your swift reply is this correct
flash 9fc00000-2100R2-v202r1256a-060303
flash image0
flash bootloader
im finding when i flash bootloader bcusb dont detect modem as a 2100 just write flash then when i flash the full flash again it detects correctly
am i missing something
cheers Mick
