Login

Mordeth · (This post was last modified: 02-12-2011, 11:19 PM by Mordeth.)

Goto your network connections and set it up as in the pic before you attempt to get into the firmware gui. If you are using Windows &....choose "IPV4".

Try both:
192.168.100.1:1337
192.168.100.1:666

[Image: 23oair.jpg]

wdw2050 · (This post was last modified: 03-12-2011, 01:01 AM by wdw2050.)

(02-12-2011, 11:18 PM)Mordeth Wrote: Goto your network connections and set it up as in the pic before you attempt to get into the firmware gui. If you are using Windows &....choose "IPV4".

Try both:
192.168.100.1:1337
192.168.100.1:666

nope it didnt

ok i connect with hyper terminal but the screen is blank and just blinking but its connect tru 666

**drewmerc** · 03-12-2011, 02:18 AM

the 666 is for the web address not telnet leave the telnet port as default

wdw2050 · 03-12-2011, 03:23 AM

no it doesn't work on port 23

**drewmerc** · 03-12-2011, 03:31 AM

reflash it

Mordeth · 03-12-2011, 05:59 PM

The instructions I gave for the static ip was so that you can determine which firmware is installed on the modem (to access the gui) and NOT for the telnet log?

Login
Username:
Password:	Lost Password?
	Remember me