Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
How fully dump Arris sb8200 firmware?
#1
I found working Arris sb8200 modem, How can I solderless fully dump Arris sb8200 firmware? The Biggest problem is My Arris sb8200 don't have serial port connector...
Thank you!
Reply
#2
Flash0 chip (W25Q32), Flash1 chip (S34ML01G200) and SOC chip (BCM3390) all related, you can not change one except you can hack it. I upload the all firmware to:
https://mega.nz/file/GeYgTDbR#6S7UqnYRWg...FVmyTNE_Hg

BTW, the serial port in the SB8200 PCB already disabled by Linux system, I do not know how the factory re-work it if need to repair, maybe just change the whole board.
Reply
#3
(03-02-2021, 07:40 AM)testpoint Wrote: Flash0 chip (W25Q32), Flash1 chip (S34ML01G200) and SOC chip (BCM3390) all related, you can not change one except you can hack it. I upload the all firmware to:
https://mega.nz/file/GeYgTDbR#6S7UqnYRWg...FVmyTNE_Hg

BTW, the serial port in the SB8200 PCB already disabled by Linux system, I do not know how the factory re-work it if need to repair, maybe just change the whole board.

Archive password ?
Reply
#4
How can I change MAC address of SB8200 to match my current modem, so that I can swap modems without calling ISP customer support?
Is MAC stored in SPI flash or NAND flash or Broadcom CPU?
Did anyone figure out NAND ECC algorithm? Modem itself reports that it's BCH-4 and it looks like BCH-4, as I see 7 bytes in OOB for each 512 byte block. But I can't verify ECC. Neither of available algorithms available in Flashcat USB work.
Did anyone figure out how to extract filesystem? Binwalk can't find anything.
Reply
#5
sprunki incredibox is a revolutionary collection of add-ons designed to elevate the Sprunki experience. Each phase introduces a unique blend of immersive themes, dynamic soundscapes, and captivating visuals, offering endless opportunities for creativity and customization.
Reply


Forum Jump:


Users browsing this thread: 3 Guest(s)