Factory Mode for Motorola SB5100

[iRandomEye]

I currently have a Motorola SB5100. Are there any other "Factory Mode Tool" that i could use to make my modem go into Factory Mode rather then the one that is already posted in the forum?

[drewmerc]

IP full http://www.haxorware.com/forums/attachment.php?aid=299 i think

[iRandomEye]

When i try to open the downloaded file this is what it says

"Component 'actskin04.ocx' or one of its dependencies not correctly registered: a file is missing or invalid"

Please help me with this error!

[drewmerc]

hope this is the correct one

[iRandomEye]

Sorry ! Realised that i had to run in Administrator mode! It works fine now! Thanks!

[iRandomEye]

I would like to enquire how will the Modem respond when i activate Factory Mode? I click on "Activate" button and the Activity light blinked for a few seconds and it turned back to solid. Help me please!

[drewmerc]

on the snmp tab
(translated from the readme)

The first step is to disconnect the coax and restart the modem (recommended putting
manually ip 192.168.100.10 Mask: 255.255.255.0 and gateway: 192.168.100.1)
Now let's "Get Decimal", choose the modem in the drop down and give it to
"Calculate", once calculated the last four bytes of the mac and can
give to "Enable" and restart the modem and the factory mode is activated, and
We can change the mac, climb certificates, etcetera.

[iRandomEye]

I was able to put the Modem into factory mode after restarting . However , i'm lost at how to change the Modems MAC Address ! I can't find a page that states so. Please help me ! Thanks!

[drewmerc]

cambiar hfc mac, can be done in 2 ways on the snmp tab and on the telnet tab

[iRandomEye]

Thank you so much ! Just another quick and last question , do we need to deactivate factory mode?