Blackcat USB won't run with SB5101 properly

[deathroll]

Hi everyone,

Today i tried to flash Haxorware to my SB5101i with Blackcat USB. But i can't do this successfully. Blackcat detecting the modem but flashing functions not seeing on Blackcat software. I use Build 326. It won't load script. I receiving "Cannot process if statement..." error.

Here is my console log.

Code:

LibUsbDotNet version: 2.2.8.104
BlackcatUSB Script Engine build: 202
Welcome to BlackcatUSB interfacing software, build: 326
Running on: Microsoft Windows XP Home Edition (32 bit)
Initializing EJTAG engine
Device connected in JTAG mode: 7,05
JTAG: IR length set to 5
JTAG engine setup successfully
Detected CPU ID: 0x334917F IMP CODE: 0x800904
Manufacturer ID: 0xBF Part ID: 0x3349
EJTAG Version support: 2.0
Target device supports DMA mode
Checking for a device specific script to automatically load
Loading script: SB5101_JTAG.bcs
Error loading: Can not process a If statement inside a If statement
No scripts to run
Disconnected from BlackcatUSB

[drewmerc]

on the first tab change the script to the 2100 one, it's for the webby but it should work just as well on a 5100 (i guess there just a typo in the current 5101 script)

[deathroll]

Loading script: DPC2100_JTAG.bcs
Setting device parameter (Intel Flash delay) to 0x32
Setting device parameter (AMD Flash delay) to 0xAF
Setting device parameter (Memory Read Delay) to 0x32
Error in script DPC2100_JTAG.bcs on line 19
Reason: error parsing command: if not (Memory(CFGFLASH).Exist)

I tried to load 2100 script but it doesn't work too. Sorry i don't understand your words in brackets

---

By the way i didn't subscribed with that modem. I didn't plug coax ever. This is a new one. Could this be the reason?

[drewmerc]

i still think it's a script issue so i'll send you here http://blackcatusb.net/

[deathroll]

Finally i succeeded. I installed a clean Windows release with drivers and .NET Framework only. I tried to flash on it and it's wok!

[drewmerc]

good for you