Hello guys,
I could really use a hand here. I have a Prolific 2303HX USB to TTL converter and I'm trying to follow Invictus tutorial from SBH to flash CG814WG v2. I don't see any pictures that he is referring to. "now you are going to connect the 4 wires from your x-ttl converter to the 4 pin header in the order shown in the picture below." so I had some trouble wiring it up to read and write via putty.
Finally, I was able to see the characters correctly after finding the correct ground pin. Right now I'm stuck that it's not responding to my keystrokes. I'm hitting P like crazy and it doesn't work. Not sure if it's the timing issue he speaks of. I also tried to type in anything while it's scanning just to see if it accepts my keystrokes but nothing shows up.
Again, SBH doesn't show the pictures to tell me how to configure putty. "once you have have everything connected, fire up putty select "serial" from the lower left hand side and make sure your settings match the ones pictured below,"
This is how i'm configured:
Baud rate 115200
8 none 1
Flow control set to NONE
Wiring wise:
GND to GND
Rxd to Txd
Txd to Rxd
I don't know if I messed the Txd on the adapter or the Rxd on the router from plugging in the wrong connections trying to figure the correct way to wire it.
If someone can help I would appreciate it.
I could really use a hand here. I have a Prolific 2303HX USB to TTL converter and I'm trying to follow Invictus tutorial from SBH to flash CG814WG v2. I don't see any pictures that he is referring to. "now you are going to connect the 4 wires from your x-ttl converter to the 4 pin header in the order shown in the picture below." so I had some trouble wiring it up to read and write via putty.
Finally, I was able to see the characters correctly after finding the correct ground pin. Right now I'm stuck that it's not responding to my keystrokes. I'm hitting P like crazy and it doesn't work. Not sure if it's the timing issue he speaks of. I also tried to type in anything while it's scanning just to see if it accepts my keystrokes but nothing shows up.
Again, SBH doesn't show the pictures to tell me how to configure putty. "once you have have everything connected, fire up putty select "serial" from the lower left hand side and make sure your settings match the ones pictured below,"
This is how i'm configured:
Baud rate 115200
8 none 1
Flow control set to NONE
Wiring wise:
GND to GND
Rxd to Txd
Txd to Rxd
I don't know if I messed the Txd on the adapter or the Rxd on the router from plugging in the wrong connections trying to figure the correct way to wire it.
If someone can help I would appreciate it.