Sorry to even ask such a dumb question , but I'm trying to install forceWare-1.4b1-mod2 on a 6141 . I was told by a few people that I should install it on both UBFI1 AND UBFI2 .
I have UBSJTAGNT 0.76 .
I opened USBGTAG-NT , detected flash no problem.
Up top in Range I go to UBFI1 , file , open firmware then write.
Then I do the same process for UBFI2.
I reboot the modem and I only have the top solid light green , it wont try the boot sequence at all. I have tried with both the 6121 and 6141 .
I've been waiting for my usbjtag forum membership to be activated for the last month
so that's why I am not asking there.
If anyone could help it would be great.
Thanks
I have UBSJTAGNT 0.76 .
I opened USBGTAG-NT , detected flash no problem.
Up top in Range I go to UBFI1 , file , open firmware then write.
Then I do the same process for UBFI2.
I reboot the modem and I only have the top solid light green , it wont try the boot sequence at all. I have tried with both the 6121 and 6141 .
I've been waiting for my usbjtag forum membership to be activated for the last month
so that's why I am not asking there.If anyone could help it would be great.
Thanks