Thread Rating:
  • 2 Vote(s) - 1.5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Tutorial to flash SPI chips with Parallel(LPT1) port
#9
A complete system chip consists of two parts, hardware and software, which are used to control the hardware part of the controller, microprocessor or digital signal processor core as well as external devices and interfaces. The design process of the system chip is mainly the design of its hardware and software.
Since the integration of system chips has reached millions of gates, engineers must adopt reusable design ideas whenever possible. Most of the SoCs use pre-defined semiconductor intellectual property cores (IP cores, including soft cores, hard cores, and solid cores) to achieve rapid design in a reusable design.
Allicdata can find something similar:  https://www.allicdata.com/list.html?category_id=2149  Blush
Reply


Messages In This Thread
RE: Tutorial to flash SPI chips with Parallel(LPT1) port - by GeneralTiger - 09-07-2019, 09:03 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)