Thread Rating:
  • 1 Vote(s) - 1 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Instruction how to connect Jtag SB5101U, Using BlackCatUSB
#2
(31-10-2011, 09:46 AM)blacklist Wrote: Instruction how to connect Jtag SB5101U.


1. Connect ONLY Jtag to SO-8
2. Open BlackCatUsb.exe (makesure its on SPI mode Ver 1.09)
3. Plugin MODEM adapter (NOT the External adapter) then unglug it.
Note: if all the lights on the Modem remains ON after unplugin, this means your jtag connected propertly.
4. Connect or Switch ON Q104 as it shown in diagram.
Note: All the lights On the modem should go OFF.
5. Connect External Adapter as it shown in Diagram.
Note: Please DO NOT have the external 5V connected too long it can harm your Modem after 1 hour of full connecte.
6. Simply Press Detect on the BlackCatUSB.exe

If You guys have any questions, please PM me

Happy Testing Smile

I dont know if its me or what but im having alos of trouble soldering wire to the chip .Do you have any tips or tell me how to make something that I can use to place on top the chip with wires connected and flash . I dunno but this is a bitch.
Reply


Messages In This Thread
RE: Instruction how to connect Jtag SB5101U, Using BlackCatUSB - by Halfwit - 07-11-2011, 03:55 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)