|
DPC2100R2
|
19-11-2011, 10:53 PM
I have try to flash my friend's Dpc2100 by max232. but in the hyperterminal I saw the prompt "p", and then I enter "p", but the menu not show up. By the way, on the max232 module, only the RXD light and PWR light would blink, nothing going with the TXD light. Does mean I mess up with wiring? But there are only 16 ways of wiring. All I had tried were not working at all. Can someone figure it out?
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
DPC2100R2 - by kieth829 - 19-11-2011, 10:53 PM
RE: DPC2100R2 - by drewmerc - 19-11-2011, 11:16 PM
RE: DPC2100R2 - by kieth829 - 19-11-2011, 11:44 PM
RE: DPC2100R2 - by drewmerc - 20-11-2011, 12:19 AM
RE: DPC2100R2 - by kieth829 - 20-11-2011, 01:28 AM
RE: DPC2100R2 - by drewmerc - 20-11-2011, 02:23 AM
RE: DPC2100R2 - by kieth829 - 20-11-2011, 02:39 AM
RE: DPC2100R2 - by drewmerc - 20-11-2011, 03:05 AM
RE: DPC2100R2 - by kieth829 - 20-11-2011, 03:33 AM
RE: DPC2100R2 - by drewmerc - 20-11-2011, 03:54 AM
RE: DPC2100R2 - by kieth829 - 20-11-2011, 05:43 PM
RE: DPC2100R2 - by drewmerc - 20-11-2011, 06:41 PM
|
