Looking for answer regarding Certs

[drewmerc]

okay I did not know how to pull out my ,non vol/ cfg out of my , Netgear CG814WGv2 so I flash it
with haxorware 11rev39 and extracted the nonvol also. the certs one by one
on the baseline privacy tad on haxorware
then i upload it the certs one by one to a webstar 2100r2 running haxorware as well
got online for about 2 week but now it's down the certs are valid
and is there any one who can point me to a , Netgear CG814WGv2
original firmware since I did not back it up or instructions how to restore
it back to original firmware I used a TTL to USB serial and putty to flash haxorware on image 1 and image 2 please help

this question should be in a thread all of it's own but whatever
let me guess you never changed the spoof on the webster to match that of a netgear (and thats the answer to why you webby wont work)
now for this to work you need to know what the spoof should be, you can download the config your isp serves you and open in vultreware and if lucky it'll be there, if not use haxor to do a 2mb backup and open it in a hex editor and look for it

once you have done that you can go about restoring your netgear simply untick the allow firmware update button in haxor the isp may simply update the firmware (you may have to set a lower spoof so this works, but you have the spoof from above) if this does not work then we move on to the next step (i dont know the next step i'll worry about it only if i need to)