08-07-2011, 06:01 AM
Hi guys I could finally manage to make the LPT cable work to dump my firmware on the MX memory MX25L6445E, it was sort of complicated cause I had to solder all the cables to each of the legs of the MX flash , and outputs and inputs, but I finally got the flash dump.
total size it's 8,388,608 I'm suspecting it flashed the whole entire MX memory not the firmware area only I don't know if that's right or wrong ,maybe I should have dumped a specific area of the MX flash .
Anyways I'm not that savvy regarding firmware manipulation,and about memory locations .So question is I would like to learn how can I extract the Certificate from the firmware dump I have. Maybe enabling factory mode enabling some hex bit .
thanks.
total size it's 8,388,608 I'm suspecting it flashed the whole entire MX memory not the firmware area only I don't know if that's right or wrong ,maybe I should have dumped a specific area of the MX flash .
Anyways I'm not that savvy regarding firmware manipulation,and about memory locations .So question is I would like to learn how can I extract the Certificate from the firmware dump I have. Maybe enabling factory mode enabling some hex bit .
thanks.