Hi,
Now I read the instructions and made sure I did it right. WHat I did was backed up the original flash 2mb and then i follow this instructions since I bought the sb5101 brand new at walmart.. I used the jtagutility by tom.
It is recommended you make a backup before flashing haxorware (or any other hacked firmware) onto your modem.
To create a 2MB backup with JtagUtility, enter the following commands:
detect
getram 9fc00000 200000
save 9fc00000 200000
(A save as dialog will appear, choose where to save your 2MB backup)
now since I did this it saved the file, after this I got the Premade 2MB Dumps with Haxorware 1.1 rev27 then i followed this instructions
detect
ldram 9fc00000
Find the dump that you want to write (I used this file 5101-11REV27.bin)
program 9fc00000 200000
after I completed this it said flash complete it was already programmed onto the modem.. now i unplugged the power plug, jtag parallel cables.. after i plugged the power plug back in and the ethernet in.. i get all flash then it went off then just the orange light illuminating (active light)..
I've tried to get in the modem using 192.168.100.10.. nothing.. im not sure if i bricked it. now I like to restore it again back to its original firmware and try it again til I get it right.
Can you please direct me to on how to do this ? I did everything you've instructed me to do and I even read the haynes guide..
Thanks in advance!!
Now I read the instructions and made sure I did it right. WHat I did was backed up the original flash 2mb and then i follow this instructions since I bought the sb5101 brand new at walmart.. I used the jtagutility by tom.
It is recommended you make a backup before flashing haxorware (or any other hacked firmware) onto your modem.
To create a 2MB backup with JtagUtility, enter the following commands:
detect
getram 9fc00000 200000
save 9fc00000 200000
(A save as dialog will appear, choose where to save your 2MB backup)
now since I did this it saved the file, after this I got the Premade 2MB Dumps with Haxorware 1.1 rev27 then i followed this instructions
detect
ldram 9fc00000
Find the dump that you want to write (I used this file 5101-11REV27.bin)
program 9fc00000 200000
after I completed this it said flash complete it was already programmed onto the modem.. now i unplugged the power plug, jtag parallel cables.. after i plugged the power plug back in and the ethernet in.. i get all flash then it went off then just the orange light illuminating (active light)..
I've tried to get in the modem using 192.168.100.10.. nothing.. im not sure if i bricked it. now I like to restore it again back to its original firmware and try it again til I get it right.
Can you please direct me to on how to do this ? I did everything you've instructed me to do and I even read the haynes guide..
Thanks in advance!!