hitron cgn2 with forceware problem

[Dj_Zeta]

Please do the flash backups correctly, for these purposes do the following:

1. Open USBJTAG NT.
2. Select Tools / Settings.
3. Select Develop / SPIFLASH / 25128.
4. Back up each flash using the same procedure.

If the backups are not done correctly it is difficult to perform an xml with precision, one way to detect the sectors and their corresponding sizes is through the Boot Log made by serial cable (console), an example of the information that has to appear:

Partitions [0] = {.name = U-Boot, .offset = 0x00000000, .size = 0x00020000 (128K)}

PD: It may not be possible for UBFI2 to find one part in Flash 1 and another part in Flash 2, the readings of both flashes are not done correctly, follow the steps outlined above.

thanks Dj Zeta

In the previous post by thalungz he doesnt mention anything about flash 2. Do i install force on flash 2 as well? As you mentioned I found the spot in flash 1 for UBFI1 and UBFI2 is not there, but i wrote it where its suggested to put it.

I reply in relation to the backups that you have published and not precisely to some xml determined, what could coincide "in part" with other xml is the UBFI1, the UBFI 2 has no relation with the sectors of the back up of the flash That you have published.

-> I suggest you do the flash backs, both above and below the pcb, with the instructions mentioned above. <-