|
Forceware programming on 6141
|
27-03-2017, 03:01 PM
Forceware modems "once flashed" are set to NOT attempt the boot sequence until you login 192.168.1.1 and set the parameters to "Modem online" etc.. Try flashing back to stock, let it boot up.. then do a "read" of all firmware, verify, then when comes back verified ok, proceed to flash UBF11 and 12
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Forceware programming on 6141 - by debug337 - 10-09-2015, 11:21 PM
RE: Forceware programming on 6141 - by Wichin12 - 11-09-2015, 02:14 AM
RE: Forceware programming on 6141 - by debug337 - 11-09-2015, 02:18 AM
RE: Forceware programming on 6141 - by debug337 - 11-09-2015, 05:13 AM
RE: Forceware programming on 6141 - by Wichin12 - 12-09-2015, 05:12 AM
RE: Forceware programming on 6141 - by debug337 - 12-09-2015, 06:11 AM
RE: Forceware programming on 6141 - by debug337 - 17-09-2015, 11:07 PM
RE: Forceware programming on 6141 - by debug337 - 19-09-2015, 03:20 AM
RE: Forceware programming on 6141 - by abescalamis - 24-03-2017, 07:03 PM
RE: Forceware programming on 6141 - by occalifornia - 24-03-2017, 07:44 PM
RE: Forceware programming on 6141 - by modembricker - 27-03-2017, 03:01 PM
RE: Forceware programming on 6141 - by Winston - 03-04-2017, 07:48 PM
RE: Forceware programming on 6141 - by eddieigo - 03-10-2017, 09:45 PM
|
