10-07-2016, 09:45 PM
(26-06-2016, 05:27 PM)Nbus Wrote:(22-05-2016, 02:16 AM)cablehater Wrote:(20-05-2016, 03:15 AM)Nbus Wrote:(19-05-2016, 05:14 PM)cablehater Wrote: were you able to read and write this box with usbjtagnt? what pinout did you use?
yes you can a full flash is 8192 KB you will need to read in spi mode
What pinout did you use for this and i also read that u can clone these but not sure
rickendo has posted the correct pin out in post 4
chip
1- chip select
2- data out to data in of reader
3 -------
4- ground Bond it to your reader ov
5- data in to data out of reader
6- clock set the speed of transfer
7- hold bonded to power when in R+W mode
8- Power 3.3v
Nbus,
Are you using pin 7 on the winbond? If so where does it go on the USB Jtag NT pin?
Read in SPI mode but choosing what target (device)??