23-06-2015, 09:01 PM
Been trying to flash these 2 flash chips for 24+ hrs, and no joy, despite following every tut claiming to be for these modems, only to find that they are for the 6120.. I know most will say they are identical, but they aint, and later posts state the fact.. I've applied 5v to pin 2, no joy, 3.3v to pin 2, no joy, 1 (apparently) has no isp pin, and the other has, yet no success in getting a flash to stick.
I'd like to say it's just a bad wiring job, but not after the amount of checking and re-checking I have done, not to mention the fact I can id both chip's, and read from them, it's quite simply like this, the flash wont stick..
Error number's etc, change like the weather, and the programmer is fine, as I just completed a test re-flash of a netgear 480, so the programmer is fine, anyone else have this kind of problem?
Any suggestions?
I'd like to say it's just a bad wiring job, but not after the amount of checking and re-checking I have done, not to mention the fact I can id both chip's, and read from them, it's quite simply like this, the flash wont stick..
Error number's etc, change like the weather, and the programmer is fine, as I just completed a test re-flash of a netgear 480, so the programmer is fine, anyone else have this kind of problem?
Any suggestions?