22-06-2015, 09:52 PM
(This post was last modified: 22-06-2015, 09:59 PM by Canis-Major.)
Thank's, I got an origional copy already, and is in the preperation folder 
Regarding this, I think I have a log of this from ecos, perhaps it would help.. see, when the modem is reset, the frequencie's are wiped in the 480 tester I have, no matter what firmware.. may not be forceware afterall, but new device's, I remember looking into the type of cmts my isp has, and there is very little access to knowledge on said device's.. they aint cisco, that's for sure.. I may even go as far as to say, what if they just did'nt use snmp, even though we view the config using the language old hat respond's too?
heheee
Keep in mind the best inventions in the world came from edinburgh
Ps, it's not just the frequencies, but entire tuning..
(22-06-2015, 09:48 PM)andy m Wrote: forceware hasnt been resolved in uk as it will not lock onto freq
only thing wht will work is alpha 1.1
Regarding this, I think I have a log of this from ecos, perhaps it would help.. see, when the modem is reset, the frequencie's are wiped in the 480 tester I have, no matter what firmware.. may not be forceware afterall, but new device's, I remember looking into the type of cmts my isp has, and there is very little access to knowledge on said device's.. they aint cisco, that's for sure.. I may even go as far as to say, what if they just did'nt use snmp, even though we view the config using the language old hat respond's too?
heheee
Keep in mind the best inventions in the world came from edinburgh
Ps, it's not just the frequencies, but entire tuning..